Avery 9860 Betriebsanleitung PDF herunterladen (Seite 30)

Default Network

The default network option allows you to reset the print server to default

settings or factory default settings.

♦ If you select default setting, any defaults set using the SET DEFAULT

Telnet console command are restored.

♦ If you select factory default, the print server is reset to factory

defaults. See “Factory Defaults

” for the list of default values. When

the print server is reset to factory defaults, you must reconfigure all

your specific network settings, including IP address, SSID, etc.

To change the setting, from the Main Menu: Select Setup, Network.

Then follow these steps.

1. Press  or  until you see

NETWORK

 Default Network

2. Press Enter/Pause.

Default Network

Default Setting 

3. After you display the option you need, press Enter/Pause.

The print server is reset to your defaults or factory defaults.

4. Press Escape/Clear until you see the Main Menu.

5. Turn off the printer and turn it back on to initialize the factory

settings.

Note: Depending on your printer’s boot method, the IP address may be

automatically assigned when you turn on the printer. The new IP

address may not be the same as the previous one.

2-14 MonarchNet2 Operating Instructions

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 113 114

Keine Kommentare

Avery 9860 Betriebsanleitung Seite 30