Avery 9416 Bedienerhandbuch

Equipment Manual©2004 Avery Dennison Corp. All rights reserved.

Loading Supply for Non-Peel Mode The printer can print on thermal-direct labels and tags. Make sure the black mark/die cut sensor is set correctly

5. Slide a roll of supply onto the supply holder. Note: If the core diameter on your roll of supply is 1 inch in diameter, remove the 1.5-inch supp

8. Turn the dial to adjust the supply guides to their widest position. Supply Guides 9. Feed the supply, printing side up, under the supply guides

13. Press the FEED button. The indicator light should be GREEN. 14. Calibrate the supply, if necessary. See “Calibrating the Supply,” for more i

4. Remove the supply holder guide from one end of the supply holder. (The supply holder is normally attached with a line to the inside of the print

Important: Tuck the plastic line attaching the supply holder to the printer down out of the way of the supply holder and supply holder guides. Othe

14. Push the peel door closed until it locks. 15. Close the cover until it locks in place. 16. Press the FEED button. A label separates from the

7. Turn the dial to adjust the internal supply guides to their widest position. 8. Feed the fan-fold labels through the supply guides, over the sup

Adjusting the Black Mark/Die Cut Sensor The printer has a black mark/die cut sensor, which it uses to sense and properly calibrate supplies. Black m

Care & Maintenance 3-1 CARE & MAINTENANCE 3 This chapter tells you how to ♦ clear supply jams ♦ clean the printhead ♦ clean the platen ro

Each product and program carries a respective written warranty, the only warranty on which the customer can rely. Avery Dennison Corp. reserves the r

Cleaning the Printhead Clean the printhead whenever you notice a decline in print quality, or after using three rolls of supply. Note: You must tu

Cleaning the Platen Roller and Printer To clean the platen roller: 1. Turn off the printer. 2. Press the cover release levers towards the front of

3-4 Equipment Manual

Troubleshooting 4-1 TROUBLESHOOTING 4 This chapter includes information on ♦ possible printing problems and solutions ♦ printing test labels ♦ ca

Problem Action Verify that supply is loaded correctly. See Chapter 2, “Loading Supplies and Printing,” for more information. Clean the printhead.

The second label shows the model number, software version, communication settings, speed, contrast, gap sensor setting, label length, and total numbe

4-4 Equipment Manual

Specifications & Accessories A-1 SPECIFICATIONS & ACCESSORIES A This chapter includes ♦ printer specifications ♦ supply specifications ♦

Supply Specifications Supply Types: Labels, tags or receipt paper Supply Widths: 0.75" (19 mm) minimum 4.25" (108 mm) maximum Supply Len

TABLE OF CONTENTS GETTING STARTED ... 1-1

28028 28028 0 0 Avery Dennison Printer Systems Division170 Monarch LaneMiamisburg, OH 453421-800-543-6650 (In the U.S.A.)1-800-387-4740 (In Canada)w

ii

Getting Started 1-1 GETTING STARTED 1 The Monarch 9416 XL® is a desktop thermal direct printer. It can print labels, tags or receipts (with or wi

Unpacking the Printer Keep all packaging material in case you need to move or return the printer. After you unpack the printer, you should have a

Connecting the Communication Cable Before the printer can accept print jobs from the host, you must ♦ connect the communication cable to the print

USB Port The printer has a USB (Universal Serial Bus) Version 2.0 communication port. Reading the Indicator Light The indicator light monitors the

Loading Supplies & Printing 2-1 LOADING SUPPLIES & PRINTING 2 This chapter describes how to ♦ load a roll of labels or tags for non-peel mo